Swing over Bed

20″

(510 mm)

Center Height

10″

(255 mm)

Swing over Cross Slide

13″

(330 mm)

Swing thru Gap

26 3/8″

(680 mm)

Length of Gap in front of D1-8 face plate

7 1/16″ 

(180 mm)

Bed Casting – width / height

16 1/8″ / 12 7/32″

(400 mm / 310 mm)

Spindle Motor Horsepower

10 HP 3 Phase

Spindle Speeds – 12 speeds 20 – 1,550 RPM (high to low)

Spindle Bore

3 1/8″

(80 mm)

Spindle Nose

D1-8 Cam lock

Spindle taper in Spindle Nose

MT-7

Morse Taper #7

Spindle taper reduction sleeve provided

MT-7 to MT-5

Cross Slide Travel

12 1/2″

(320 mm)

Cross Slide Width

7 3/32″ 

(180 mm)

Cross Slide Lead Screw Pitch

.200″ / rev

Cross Slide Resolution per division

0.001″

(on diameters)

Carriage Lead Screw Diameter

1 1/2″

(38 mm)

Carriage Lead Screw Pitch

4 TPI 

(6 mm pitch)

Feed Rod Dimensions

7/8″ hexagon

23 mm hexagon

Compound Top Side Travel

10″

(255 mm)

Compound Top Slide Width

4 11/32″

(110 mm)

Cutting Tool Height Maximum

1.0″ x 1.0″

(25 mm x 25 mm)

Quill Diameter

2-15/16″

(255 mm)

Quill Stroke

6 5/16″

(160 mm)

Quill Taper

MT-5

Morse Taper #5

Quill Tang Drive and Drift-Slot for Tailstock

included

Tailstock Body set-over adjustment

±0.04″

±1 mm

Leadscrew Diameter / Pitch

1 1/2″ / 4 TPI

38 mm / 6 mm pitch

Thread Cutting Range – 60″ pitches

2 – 112 TPI

Thread Cutting Range – 60 metric pitches

0.2 – 14 mm

Thread Cutting Range – 50 diametral pitches

4 – 112 M.P.

Thread Cutting Range – 50 module pitches

0.2 – 7 M.P

Feeds – Longitudinal – 50 Feeds

0.0014″ – 0.0387”/rev.      (0.037 – 1.04 mm / rev)

Feeds – Cross – 50 Feeds

0.0007″ – 0.01935″/rev.    (0.0185 – 0.52 mm/ rev)

Feed stop shaft

4 adjustable automatic feed stops to disengage the longitudinal feed

Coolant Pump

1/8 HP

Machine Power Requirements (440 vac optional)

220 vac  /  3 Phase  /  30 amps